Accessories And Attachments - DeWalt DWE4011 Guide D'utilisation

FIG. 1
A
C
F
B
A. Spindle lock button
B. Spindle
C. Side handle
D. Backing flange
INTENDED USE
This grinder is designed for professional grinder, sander, wire brush,
polisher or cut-off applications.
DO NOT use under wet conditions or in presence of flammable
liquids or gases.
This grinder is a professional power tool. DO NOT let children come
into contact with the tool. Supervision is required when inexperienced
operators use this tool.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of injury, turn unit off
and disconnect it from power source before installing and
G
H
D
E
E. Threaded clamp nut
F. Guard
G. Slider switch
H. Guard release lever
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
ATTACHING SIDE HANDLE (FIG. 2)
The side handle (C) can be fitted to either side of
the gear case in the threaded holes, as shown.
Before using the tool, check that the handle is
tightened se cure ly. Use a wrench to firmly
tighten the side handle.
Rotating the Gear Case
(Fig. 3)
1. Remove the four corner screws attaching
the gear case to motor housing.
2. Without separating the gear case from
motor housing, rotate the gear case
head to desired position.
NOTE: If the gear case and motor housing
become separated by more than 1/8"
(3.17 mm), the tool must be serviced and
re-assembled by a D WALT service center.
e
Failure to have the tool serviced may cause
brush, motor and bearing failure.
3. Reinstall screws to attach the gear case to the motor housing.
Tighten screws to 18 in.-lbs. torque. Overtightening could cause
screws to strip.

Accessories and Attachments

It is important to choose the correct guards, backing pads and flanges
to use with grinder accessories. See the Accessories Chart for
information on choosing the correct accessories.
WARNING: Accessories must be rated for at least the speed
recom mended on the tool warning label. Wheels and other accessories
running over rated accessory speed may burst and cause injury.
8
FIG. 2
C
FIG. 3
90˚
90˚