Requirements For The Installation Location - Graef H 9 Notice D'utilisation

Manual Universal Slicing Machine H 9 / H 91
unpacking
To unpack the unit, proceed as be-
low:
EN
Take the unit out of the carton.
‹
Remove all pieces of the pack-
‹
ing.
Remove any possibly extant la-
‹
bels on the manual universal
slicing machine (do not remove
the rating plate).
Dispose of the pack-
ing
The packing protects the unit from
shipping damage. The packing
materials are selected for their en-
vironmental compatibility and from
disposal aspects so they are recy-
clable.
Returning the packing to the ma-
terials circuit saves raw materials
and reduces the accumulation of
waste. Dispose of packing material
that is no longer needed at a col-
lection point for the »Green Point«
recycling system.
important!
► If possible, save the original
packing during the unit's
warranty period to be able to
properly pack the unit in case
of a warranty claim.
14
Requirements for the in-
stallation location
For safe and flawless operation of
the unit, the place of location must
meet these prerequisites:
■ The unit must be set up on a firm,
flat, level, and non-slip base that
has sufficient load bearing capac-
ity.
Select the place of location so that
■
children cannot reach the sharp
blade in the unit.
Setup and Functioning
Overview
1) Handle
2) Slicing thickness control
3) Stainless steel carriage
4) Serrated blade
5) Carriage guide profile
2
4
3
1
5
6