Danger Caused By Electric Current; Safety Instructions For The Electrical Connections; Requirements On The Installation Location - Graef SKS 500 Instructions D'utilisation

size and shape of the slicing material does not allow its use.

Danger caused by electric current

Mortal danger is caused by contact with energised cables or
components!
Please observe the following safety instructions in order to prevent
an exposure to electric current:
- Do not use the unit if the mains cable or plug are damaged.
- In this case, you should let the Graef Customer Service install a
new connection cable before using the unit again. This may be
done also by an authorised specialist.
- Do not open the housing under any circumstances. If live
connections are touched or the electrical and mechanical
construction are modified, there is the danger of electric shock.
- Never touch live parts. This can cause an electric shock and may
cause even death.

Safety instructions for the electrical connections

For safe and fault-free operation of the unit, the following
requirements have to be met during the electrical connection:
- Before connecting the unit, compare the connecting data (voltage
and frequency) on the type plate with those of your energy
network. These details must correspond so that no damage occurs
to the unit. In case of doubt ask your trained electrician.
- The socket has to be protected at least by a 10 amps circuit breaker.
- Make sure that the power cable is not damaged and is not laid
across hot surfaces or sharp edges.
- The connecting cable must not be stretched tightly.
- The electric safety of the unit is ensured only when it is connected
to a socket with protective conductor installed correctly. Operation
on a socket without protective conductor is forbidden. If in doubt,
let the house installation checked by a trained electrician. The
manufacturer shall not assume responsibility for damage which
has been caused by absent or interrupted protective conductor.

Requirements on the installation location

For safe and fault free operation of the unit, the following
DE
EN
FR
NL
IT
ES
DK
PL
23