Using The Phone - Caberg JUST SPEAK Sécurité Et Instructions D'utilisation

helm_mod_D1359bluetoothOK 12-02-2007 12:07 Pagina 30
ENG
The volume can change from min to max (6 levels).
Every time you press the button (short press), confirmed by a beep in the earpiece, the volume goes up
a level until it reaches the max volume (indicated by a high-pitched tone).
Then, with each short press of the button the volume drops until it reaches the min volume (indicated by
a low-pitched tone).
If you then press the button again, the volume starts rising again...
The next time you switch the helmet on, the last volume setting is automatically restored.
N.B.: In Intercom mode we recommend starting with the min volume setting and then gradually increase
this until you can hear the other person's voice clearly. This way you get the best balance between the
volume of the voice and the general background noise generated by the helmet. If the volume is too high,
the background noise is also increased pointlessly.
The phone function has no background noise problems and so the volume can be set at will.
In the case of Jet helmets, the microphone must be placed as close to the mouth as possible.

USING THE PHONE

CAUTION: not all phones Bluetooth® have the same compatibility with the CABERG JUST SPEAK
system. See www.stilo.it to check the compatibility of phones Bluetooth® with the CABERG JUST
SPEAK system.
The audio quality and level may vary from phone to phone depending on the "bridge" used by
your phone.
CAUTION: If the volume is too high, it may distract you when driving, leading to danger veicolo
or reduced perception of external noises. Adjust the volume before using the system when
moving.
Answering a call.
If the phone paired to the helmet receives an incoming call, you hear "ringing" tones in the earpiece:
press the button (short press) to answer the call.
N.B.: some phones will actually reproduce your normal ringing tone in the helmet.
The Master helmet will also warn you of an incoming call when in communication with the Slave in
Intercom mode (Intercom mode phones only); the start of Master helmet/phone communication is indica-
ted by a double tone.
28