Adjusting The Volume - Caberg JUST SPEAK Sécurité Et Instructions D'utilisation

helm_mod_D1359bluetoothOK 12-02-2007 12:07 Pagina 29
ENG
CAUTION: software upgrades for the phones listed in the table may affect their compatibility with the
CABERG JUST SPEAK system.
The CABERG JUST SPEAK system is compatibile with all Bluetooth® mobile phones when it comes to
the basic functions (making and taking calls), but there may be limited compatibility for more advanced
functions.
See www.stilo.it for full details of compatibility.
Switch the helmet on (whether Master or Slave).
After a few seconds the helmet is ready to work with the paired phone, which must, of course, be swit-
ched on. If the paired helmet and phone fail to find each other, switch them both off and on again or
repeat the pairing procedure.
N.B.: Some phones (see www.stilo.it) need to be connected to the helmet by pressing the button (short
press) after being switched on.
Check your phone's operating modes and special options.
N.B.. A Master helmet, once switched on and connected to the mobile phone, may then be connected to
a Slave helmet (provided this is already switched on). Simply press the multifunction button (medium
press) on the Slave: the helmets must be within a radius of 10 metres.
If the Master or Slave are connected to a phone that doesn't allow for Intercom mode, you need to swit-
ch both helmets off and then switch the Slave on first and only then the Master to work in Intercom mode.
This way both the helmets disconnect from their phones and automatically connect in Intercom mode.
How to switch the helmet off.
Press the multifunction button (long press) until the led is steady, confirmed by a low-pitched tone (clo-
sing) in the earpiece. Release the button. The led goes off.
N.B.: If the system fails to respond to the multifunction button commands, charge the battery for a few
minutes (5-10 minutes). The device then resets. If the battery is low, just a few minutes of charging are
still enough to check proper efficiency.

ADJUSTING THE VOLUME

The multifunction button lets you adjust the volume during communication (with either another helmet or
a phone).
27