Adjusting The Volume; Configurator Mode; Friend' Helmets - Caberg JUST SPEAK Mode D'emploi

EN

Adjusting the volume

The multifunction buttons let you adjust the volume during communication (with either another helmet or a phone).
The volume can change from min to max (8 levels).
+
Every time you press the
(indicated by a triple high-pitched tone).
-
Each short press of the button drops the volume until it reaches minimum (indicated by a triple low-pitched tone).
The next time you switch the helmet on, the last volume setting is automatically restored.
NOTE: In Intercom mode we recommend starting with the min volume setting and then gradually increasing this until you can hear the other person's
voice clearly. This way you get the best balance between the volume of the voice and the general background noise generated by the helmet. If the
volume is too high, the background noise is also increased pointlessly.
The phone function has no background noise problems and so the volume can be set at will.
In the case of Jet helmets, the microphone must be placed as close to the mouth as possible.

Configurator mode

The CABERG JUST SPEAK system has software for PC Windows that lets you configure all the system's functions easily and simply.
The following are required to be able to use the configurator:
• PC Windows (Windows XP or higher);
• Bluetooth® peripheral;
• Microsoft.NET Framework 3.5 (minimum)
You can set the following options using the configurator software:
• Name of the helmet
• Volume of the intercom mode
• Volume of stereo music mode (A2DP, Bluetooth® MP3 player )
• Volume of mode with active phone call
• Stereo mode (caution: the default setting of the system is mono mode in order to comply with the Highway Code in force in most countries)
• Deactivation of right-hand earpiece
• Definition of friends' helmets.
When you have completed the configuration, save it on the computer so that you can subsequently edit it.
With the helmet switched off, press both buttons
this means that the communicator is in the configurator mode.
Select the previously saved configuration on the configurator and press the appropriate Enter button of the configuration.
Then select your helmet from the Bluetooth® devices displayed and enter. A double high-pitched tone confirms configuration whilst a double low-
pitched tone warns of an error, in any case the electronic board automatically switches off.
Friends' helmets
The friends' helmets function makes the pairing procedure between helmets easier, so that you can be connected with up to 10 helmets.
Each JUST SPEAK system is identified by a univocal code (FriendAddress).
26
button (short press), confirmed by a beep in the earpiece, the volume goes up a level until it reaches the max volume
-
+
and simultaneously until you hear a single high-pitched tone and the LED flashes quickly: