Pairing A Gps Navigator With The - Caberg JUST SPEAK Manuel D'instructions

Note: It is not possible to connect a music player with A2DP and another
CABERG JUST SPEAK system (intercom mode) at the same time. Inter-
rupt the Bluetooth
ly before starting the A2DP player. To re-establish Bluetooth
communications, stop the music by pressing - for 3 seconds then con-
nect the intercom manually by pressing the
3.5 GPS NAVIGATORS
3.5.1 Pairing a GPS navigator with the CABERG JUST
SPEAK system
The navigator/CABERG JUST SPEAK pairing operation is managed on
the navigator. Consult the handbook for the navigator with Bluetooth
interface, in the section dealing with connecting Bluetooth
check the pairing procedure, as this is different for every navigator. Then
use the navigator to pair the navigator and CABERG JUST SPEAK system.
The process is the same as that described in the paragraph above ("3.2.1
Pairing with a Bluetooth® cellphone"), so repeat the actions described in
points 1 to 8, using the GPS navigator rather than the cellphone. Once the
CABERG JUST SPEAK system is connected to the Bluetooth
the CABERG JUST SPEAK system can receive GPS information. If the
pairing is not successful, switch off the CABERG JUST SPEAK system and
repeat the pairing operation from the start.
Note: the functions described can vary according to the type of
navigator or software. This could affect compatibility with the CABERG
JUST SPEAK system.
To use the CABERG JUST SPEAK system connected to a GPS navigator,
proceed as follows:
1 - Switch off the CABERG JUST SPEAK system.
2 - Switch on the previously paired satellite GPS device.
intercom manually by pressing the
®
button brief-
intercom
®
button briefly).
devices, to
®
navigator,
®
UK
®
47
ENGLISH