Bluetooth ® Intercom - Caberg JUST SPEAK Manuel D'instructions

Call transfer
(HFP profile)
Attention: Obey all road traffic laws. Both hands should
be used to control the motorcycle when riding. All opera-
tions on the CABERG JUST SPEAK system should be car-
ried out while the motorcycle is stationary.
3.3 bluetooth
®
To use the CABERG JUST SPEAK as an intercom, both helmets - passen-
ger and driver - must be equipped with a CABERG JUST SPEAK, or similar
compatible device Contact Caberg s.p.A. or your retailer for a list of compat-
ible devices.
For two CABERG JUST SPEAK systems to communicate with each other,
they must first be paired – in other words, they must "meet".
3.3.1 Pairing two CABERG JUST SPEAK kits
• PActivate pairing mode on bothCABERG JUST SPEAK systems (starting with
the system turned off, press and hold
rapidly), as described in points 1,2 and 3 of "Pairing with a Bluetooth
cellphone" (paragraph 3.2.1).
• When both systems are in pairing mode, briefly press
met. This must be done for the pairing operation to be completed successfully .
• After a few seconds the CABERG JUST SPEAK systems recognise each
other and a tone signals correct pairing. Intercom communications are now
enabled.
If the operation is not successful, switch off both CABERG JUST SPEAK sys-
tems and repeat the operation from the start.
To transfer an existing call from the CABERG
JUST SPEAK system to the cellphone, press
and hold + and - buttons at the same time
for 2 seconds.
intercom
button until both LEDs begin to flash
button on rider's hel-
UK
enabled
®
43
ENGLISH