Functions With Cellphone - Caberg JUST SPEAK Manuel D'instructions

Note: If, when the CABERG JUST SPEAK system is switched on again, it
does not connect automatically, then connect to the cellphone manually
(this operation is described in the cellphone handbook) or with the CA-
BERG JUST SPEAK system by using a medium pressure on the middle
ON/OFF button
Note: the pairing is saved by CABERG JUST SPEAK and the cellphone,
and is not lost when they are turned off, so it is only necessary to carry
out this operation once.
Note: The CABERG JUST SPEAK system can remember several Blue-
tooth devices, as well as a CABERG JUST SPEAK for intercom commu-
®
nications. When switched on, the CABERG JUST SPEAK will look for the
last three paired devices in order and connect to the first device available
(no MP3 player). If the device connected previously is not in the last three
or is not connected automatically, connect it manually. (In the event of error
repeat the pairing process).
3.2.2 Reset pairing function
It is possible to delete all paired devices from the system memory. This op-
eration is not reversible – after the reset you will have to pair the cellphone or
other Bluetooth® compatible devices again.
Proceed as follows:
• Activate the pairing mode for the system (press
begins to flash rapidly) (see paragraph 3.2.1 on pairing, points 1, 2 and 3).
• While CABERG JUST SPEAK is in pairing mode, press
at the same time for two seconds, then release them when you hear a tone.
The system will emit a special confirmation tone and the LED will switch to
slow flashing.

3.2.3 Functions with cellphone

To carry out operations with the cellphone, the cellphone must already paired
for about 2 seconds.
UK
button until the LED
+ and - buttons
ENGLISH
41