Caberg JUST SPEAK Manuel D'instructions page 43

3 FUNCTIONS
UK
and connected to the CABERG JUST SPEAK (see paragraph 3.2.1). When the
cellphone is connected to the CABERG JUST SPEAK, the connection is dis-
played on the phone screen. The symbol used varies according to the phone
model (please refer to its instruction manual). The connection is carried out
automatically when the system is switched on. It is, however, possible to con-
nect or disconnect by using the CABERG JUST SPEAK system (see the fol-
lowing table of commands) or the telephone.
Call answer
Disconnect/reject call
Voice call
(with phones that
support this function)
Last number recall
(with phones that
support this function)
Connect phone
connection
(HFP profile)
Disconnect phone
(HFP profile)
(with phones that
support this function)
42
ENGLISH
Briefly press any button when you hear the call
signal.
To interrupt or reject an incoming call, press and
hold button for about 2 seconds until you
hear the tone. Note: Call rejection, disconnec-
tion and call transfer are not possible on phones
paired in HSP (Headset Profile).
To make voice calls (with cellphones that allow
it) or give other voice commands, press and
hold button for about two seconds, until you
hear the tone.
To recall the last number briefl y press then re-
lease + and - buttons at the same time. The
system emits a sequence of tones.
To connect the phone or other Bluetooth
press and hold
until the tone.
To disconnect the phone or other Bluetooth
devices, press and hold + and -
2 seconds.
button for about 2 seconds,
buttons for
device
®
®