Caberg JUST SPEAK Sécurité Et Instructions D'utilisation page 26

helm_mod_D1359bluetoothOK 12-02-2007 12:07 Pagina 26
ENG
flashing and the helmet emits a high-pitched tone. (CAUTION: The led comes on and the helmet
sounds after just 4 seconds. This means that the helmet is on: keep the button down to enter pai-
ring mode, indicated by the fast flashing of the led and the tone heard in the earpiece).
CAUTION: Do not hold for too long, otherwise you could start Hand-free pairing, which doesn't
allow for helmet/helmet pairing.
Repeat for both helmets.
Rapid flashing of the leds means that both helmets are ready for pairing. At this point either helmet could
be paired as the Slave or Master.
Master Helmet:
Make a short press on the multifunction button. This tells the system that this helmet will be the Master.
The system asks it to find the Slave to be paired.
Slave Helmet:
Do nothing.
After about 5 seconds, both helmets emit a tone and the leds starting flashing slowly instead of rapidly.
This means that the helmets have been paired and so are now ready for Intercom mode.
If, after pairing, the two helmets are not linked, it means that the pairing procedure has failed. This is indi-
cated by a low-pitched tone from the helmet. Switch both helmets off and repeat the Master/Slave pai-
ring procedure.
If two paired helmets move more than 10 metres away during communication, the communication will be
lost:
to reconnect them simply bring them closer together and press the button on the Master helmet for
seconds (until you hear a tone in your earpiece).
How to pair a Bluetooth® mobile phone to the CABERG JUST SPEAK system
The mobile phone/helmet pairing procedure is done via the mobile phone.
Mobile phones use two types of pairing: the Head-set and the Hands-free protocols. See www.stilo.it to
check compatibility.
The helmet (whether Master or Slave) is interpreted by the phone as a Bluetooth® earpiece. See your
Bluetooth® phone manual (pairing Bluetooth® devices) to check which pairing procedure applies, as this
24