Caberg JUST SPEAK Sécurité Et Instructions D'utilisation page 27

helm_mod_D1359bluetoothOK 12-02-2007 12:07 Pagina 27
ENG
varies from phone to phone.
Once you know the pairing procedure for your phone, you can start pairing the helmet.
Phones using Head-set protocol
The phone/helmet pairing procedure is done via the phone.
The helmet is interpreted by the phone as a Bluetooth® earpiece.
Start with the helmet switched off.
Enter the pairing mode by pressing and holding the multifunction button on the helmet for 10 seconds
until the led starts flashing rapidly and you hear a high-pitched tone, indicating that pairing can start.
(N.B.: the led comes on after 4 seconds and the helmet emits a low-pitched tone. Keep pressing the but-
ton until the tone becomes a high-pitched one and the led starts flashing rapidly).
CAUTION! Do not hold the button too long: otherwise you enable the HF pairing mode.
You need to complete pairing quickly (within 40 seconds) using your phone and the specific Bluetooth®
pairing procedure for your phone.
Stilo xxxxx is one of the options in the list of devices on the phone display.
Select Stilo xxxxx.
Enter 0000 as the password.
The helmet confirms successful pairing by emitting a tone and the led starts flashing slowly.
Switch the phone off and back on again to save the pairing data.
Pairing is saved by the helmet and the parameters are not lost even when you switch the helmet off.
If pairing is unsuccessful, switch the helmet off (see instructions on how to switch off the helmet) and then
repeat the pairing procedure from the beginning.
N.B.: some phones (see www.stilo.it) must be connected to the helmet after being paired by pressing the
button and then releasing this immediately. This brief connection procedure needs to be repeated each
time you switch the helmet on (switch the helmet on and then briefly press the button and release).
Check your phone's specific Bluetooth® operating modes and any options.
To double-check that a helmet and Bluetooth® phone are connected, make a call to the phone paired
with the helmet: the phone will start ringing and then you should hear a "bip-bip" inside the helmet mea-
ning that helmet/phone communication is starting. The earpiece will then repeat the tones or ringing tone
for an incoming call. Press the multifunction button to accept the call (short press).
25