Troubleshooting - Dreve EyeVolution MAX Mode D'emploi

EyeVolution ® MAX

12. Troubleshooting

Fault Cause
Device shows no Incorrect mains
function connection
Main switch off
Internal cabling is
defective
Plug-in power supply
unit is defective
LED lights up, electronics Electronics are defective
without function
Rotary plate without
Function deactivated
function
Device cover is open
Cable connection to
rotary motor (16) is
defective
Rotary motor (16) is
defective
Electronic module is
defective
Motor adapter (25)
rotates continuously
Time programmes can
Main switch off
not be activated
Device cover is open
Internal cabling is
defective
26
Troubleshooting
Check mains connection
Switch on main switch
Internal cabling must be
checked by a specialist.
Replace the plug-in
power supply unit
Electronics must be
checked by a specialist
Activate with pressure
switch (5)
Close cover (12)
Examine the cabling
The motor must be
examined by a special-
ist, and replaced if
necessary
The electronics must be
examined by a special-
ist, and replaced if
necessary
Tighten the motor
adapter threaded pin
Switch on the device
Close cover (12)
Internal cabling must
be checked by a spe-
cialist
Fault Cause
LED circuit board (9) is
defective
Electronic module is
defective
Micro-switch (15) is
defective
Polymerisation time Electronic module is
does not end automati- defective
cally
Both micro-switches
Polymerisation process
is not interrupted when (15) are defective
the cover is opened
Unsatisfactory polymer- Polymerisation time is
too short
isation results
Material reacts to
fluctuating wavelengths
LED circuit board (9) is
soiled
LED circuit board is
damaged
Troubleshooting
The LED circuit board
must be examined by a
specialist, and replaced
if necessary
The electronics must
be examined by a
specialist, and replaced
if necessary
The micro-switch must
be checked by a spe-
cialist and replaced if
necessary
The electronics must
be examined by a
specialist, and replaced
if necessary
Deactivate the
device immediately.
The micro-switch must
be checked by a
specialist and replaced
if necessary
Extend the polymerisa-
tion time
Replace the material
Clean the LED circuit
board carefully
Examine the LED
circuit board, replacing
if necessary
27