Ordering Spare Parts; Waste Disposal; Maintenance And Cleaning - EINHELL NHT 2000 Mode D'emploi

Anleitung NHT 2000_SPK7:_
GB
7.7 Setting the automatic switch OFF time
Press the "TIME" pushbutton; the display will show
"1hr". With each press of the "TIME" pushbutton you
increase the switch off time by 1 hour within a range
of 1 – 8 hours. The appliance switches off
automatically once the set time has elapsed. To
switch off the timer before the set time has elapsed,
press the "SWITCH" pushbutton.
7.8 Switching on the oscillation function
Press the "OSC" pushbutton. The appliance swivels
approximately 45° to the left and 45° to the right. To
switch off the "oscillation" function and have the
appliance blow in one specific direction only, press
the "OSC" pushbutton again.
7.9 Overheating guard
In case of excessive heating, the appliance shuts
down automatically, a short warning signal sounds
and the display goes off. Should this occur, set the
mains voltage switch (13) to "0" and pull out the
power plug. Allow the appliance to cool down for
about 15 minutes. After eliminating the cause (e.g. a
covered air grille), the appliance can be switched on
again as described in 7.1. It will not be possible to
switch on the appliance if it has not cooled
sufficiently. If the "SWITCH" pushbutton is pressed
repeatedly, a warning signal will sound and the
display will flash. Switch off the appliance with the
mains voltage switch (13), pull out the power plug
and wait for a few more minutes. If the overheating
guard triggers repeatedly, please contact your
customer service center (in Germany ISC GmbH).

8. Maintenance and cleaning

Before carrying out any cleaning and maintenance
work the appliance must be turned off,
disconnected from the power supply and cooled
down.
Maintenance and repair work may only be carried
out by an electrical servicing contractor or your
customer service center.
Check the mains lead at regular intervals for signs
of defects or damage. A damaged mains lead may
only be replaced by an electrician or the customer
service responsible for your country in compliance
with the relevant regulations.
Use a damp cloth to clean the casing.
8
08.05.2007 15:15 Uhr Seite 8
9. Storage
The radiator has to be stored in a dry place, covered
if possible.

10. Ordering spare parts

Please provide the following information on all orders
for spare parts:
Model/type of machine
Article number of the machine
ID number of the machine
Number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info

11. Waste disposal

The appliance, accessories and packaging should be
disposed of in an environmentally-friendly fashion,
i.e. by taking them to a recycling depot. Plastic parts
are coded for purposes of separation when recycling.