Cleaning And Storage - GGP ITALY WM Série Manuel D'utilisation

clothing (ties, scarves, etc.) or hair closer to
the top part of the engine.
IMPORTANT
Do not operate on over 20°
inclines to prevent malfunctioning of the
engine.
5.5
STOPPING THE ENGINE DURING
MOWING
a) Move the throttle to «SLOW».
b) Allow the engine to run at minimum speed for
at least 15-20 seconds.
c) Stop the engine following the instructions
contained in the machine's Instructions
Manual.
5.6
STOPPING THE ENGINE AFTER
MOWING
a) Move the throttle to «SLOW».
b) Allow the engine to run at minimum speed for
at least 15-20 seconds.
c) Stop the engine following the instructions
contained in the machine's Instructions
Manual.
d) When the engine is cold, disconnect the
spark plug (1) and remove the starter key (if
present).
e) Remove any debris from the engine and
especially around the exhaust silencer to
reduce the risk of fire.
5.7

CLEANING AND STORAGE

a) Do not spray with water or use hydraulic
lances to clean the exterior of the engine.
b) Use a compressed air gun (max. 6 bars) for
preference, thus preventing debris and dust
from penetrating inside.
c) Store the lawnmower (and the engine) in a dry
place, sheltered from severe weather condi-
tions and sufficiently ventilated.
5.8
LONG STORAGE (over 30 days)
In case the engine has to be stored for a long
time (for example at the end of the season), a
few precautions are needed to help the future
start-up.
a) To prevent the formation of deposits inside
the tank, empty it of fuel by unscrewing the
carburettor float chamber plug (1) and col-
lecting all the fuel in a suitable container. At
the end of the operation remember to screw
the plug (1) back on and fully tighten it.
b) Remove the spark plug and pour about 3 cl of
clean engine oil into the spark plug hole, then,
having blocked the hole with a rag, run the
starter motor briefly to turn the engine for a
few revs and distribute the oil over the inner
surface of the cylinder. Finally replace the
spark plug without connecting the cable cap.
5
EN