Standards Of Use; Before Every Use - GGP ITALY WM Série Manuel D'utilisation

4
EN

5. STANDARDS OF USE

5.1

BEFORE EVERY USE

Before every use, perform the following checking
procedures in order to assure a regular opera-
tion.
5.1.1
Check oil level
See the specific chapter (8.1) for the oil to be
used.
a) Place engine level.
b) Clean around oil fill.
c) Unscrew the cap (1), clean the end of the dip-
stick (2) and replace it, resting the cap on the
filler, as seen in the illustration, without tight-
ening it.
d) Remove the cap with the dipstick and check
the oil level that must be between the «MIN»
and «MAX» marks.
e) If oil is required, add oil of the same kind up
to the «MAX» mark, being careful not to spill
any outside the oil fill.
f) Fully tighten the fillercap (1) and wipe off any
spilled oil.
5.1.2
Check air cleaner
The efficiency of the air filter is fundamental for
the engine to work properly. Do not start the
engine if the filtering element is missing or bro-
ken.
a) Clean around the filter cover (1).
b) Remove the cover (1) by unscrewing the two
knobs (2 - TRE0701 - TRE0801), or by press-
ing the tabs (2a - TRE0702).
c) Check the condition of the filtering element
(3). It must be intact, clean and in perfect
working order; if not, either carry out mainte-
nance or replace it (see 6.5).
d) Put the cover (1) back.
5.1.3
Refuelling
IMPORTANT
Do not drip fuel onto the
plastic parts of the motor or the machine to
prevent damaging them and remove all traces
of spilt fuel immediately. The warranty does not
cover damage to plastic parts caused by fuel.
The fuel characteristics are given in the specific
paragraph (see 4.2 and 8.1).
Refuelling must be made when the engine is
cold, following the instructions contained in the
machine's Instructions Manual.
5.1.4
Spark plug cap
Firmly connect the cable cap (1) to the spark
plug (2), making sure that there are no traces of
dirt inside the cap and on the spark plug termi-
nal.
5.2
STARTING THE ENGINE (cold)
The engine must be started in the way described
in the machine's Instruction Manual, always
making sure that any device (if present) that
could cause the machine to advance or the
engine to stop is disengaged.
a) Move the throttle to «CHOKE».
b) Turn the starter key as described in the
machine's instruction manual.
After a few seconds, slowly move the throttle
from «CHOKE» to either «FAST» or «SLOW».
5.3
STARTING THE ENGINE (hot starting)
•) Follow the whole cold-starting procedure
with throttle control in «FAST» position.
5.4
USE OF THE ENGINE IN OPERATION
Maximum revs must be used to optimise the
engine's yield and performance, by setting the
throttle trigger to «FAST».
WARNING!
from the silencer and surrounding areas
that can become extremely hot. With the
engine running, do not get loose-fitting
Keep your hands away