REBER 9600 N Notice D'utilisation Et Entretien page 40

If the propeller (10) jams, before taking any further action on the machine put the
switch onto the "OFF" (-0-) position and unplug from the power point. When the
work is finished, unscrew the funnel (8), unhook the drip pan (12), and turn the
filter cone (11) clockwise to remove the propeller (10) and the tow pin with the
spring. Remove the cast iron casing (9) from the reduction gear cover (6), then
wash, carefully dry and eventually grease all the parts that have been exposed to
the food.
MEAT MINCER UNIT
Body and ring nut are made in aluminum for ART. 8820 N: 9502 N V 230/50 Hz:
9556 N – V 240/50 Hz: 9557 N – V 115/60 Hz, other models Body, ring nut and
propeller are made of tin-plated cast iron (or Stainless Steel Aisi 304), plate and
self-sharpening knife in hardened steel, pestle in Moplen, dish in 18/10 stainless
steel. On request there are crown for fitting and funnels for bagging in Moplen,
plates with holes of different sizes according to need.
USING THE ELECTRIC MEAT MINCER
This appliance shall not be neither used nor handled nor cleaned by children. Keep
the appliance and its cord out of reach of children
Before operate, wash with boiling water and carefully dry all the parts that have
been exposed to the food. On first utilization, grind for 5 min. some meat scrap to
eliminate all possible processing residues.
Before each use, lubricate the propeller pin (where the plate is mounted) and the
nylon bush in contact with the propeller to prevent overheating friction.
Screw the ring nut and never remove during the functioning of the meat mincer
When the work is finished, to dismantle the meat chopper, turn the ring nut (11)
anticlockwise, remove the knife (10), the plate (9) and the propeller (8). Remove
the cast iron body (7) from the reduction gear cover (6), then wash, carefully dry
and eventually grease all the parts that have been exposed to the meat. "Reber"
electric meat choppers are fitted for operation with plates having holes of diameter
from 3 mm to 12 mm. Reber decline all liability concerning damage or accidents
deriving from using plates having holes of diameter greater than 12 mm.
GRATER UNIT
Body and handle in aluminum, roller in tin-plated steel and collection drawer in a
plastic material for foodstuffs. The grater is inserted onto the geared motor by
means of an axial revolution multiplier with nylon gears supplied in the package.
40