Publicité
Compressor protection function
The compressor protection function gives the compressor a 3-minute delay to protect the
device. When using functions for cooling and dehumidifying, keep an interval of at least 3
minutes between each power cycle.
Automatic defrost
Frost is detected when the device is operating in the cooling or dehumidify mode and the built-
in temperature sensor detects that the temperature is lower than -1 °C. The compressor will
stop temporarily. The device starts to defrost automatically and indicator lights start blinking.
After the temperature has risen sufficiently, the compressor will start working automatically.
After operation
CAUTION
Do not use the power cable to unplug or carry the device. Do not wind the
power cable too tightly or in sharp corners. Do not wrap the power cable around
the device.
1. Make sure the device is switched off and the plug is removed from the power outlet.
2. Let the device cool down before touching it.
3. Remove the hot air outlet hose from the window.
4. Wind the power cable.
Maintenance
WARNING
Do not perform any repairs or modifications to this device.
Maintenance and repairs must be carried out by a EUROM authorized professional. If the
electric cable and/or electric plug is damaged, it should be replaced by the manufacturer or its
service employee or persons with similar qualifications to prevent risks.
Repairs must be carried out in accordance with the appliance manufacturer's recommendations.
Maintenance and repairs requiring the assistance of other qualified personnel must be carried
out under the supervision of a person specialized in the use of flammable refrigerant media.
National gas regulations must be complied with. Persons working with or intervening in a
refrigerant circuit must hold appropriate certification issued by an accredited body certifying
that the person concerned is competent to handle refrigerant media in accordance with a
special assessment recognized by industry associations. All parts are specially designed for use
in air conditioners with R290 refrigerant. These parts are non-incendiary and should only be
replaced with identical repair parts.
43
Publicité
