Fracarro D-Matrix 8T Instructions D'emploi page 51

In the "Added PID list" (see figure 11), you can perform the following settings: enter the PID to add which is
shown under the "remapped value" column, select the signal input (INPUT 1, INPUT 2, INPUT 3, INPUT 4, IN-
PUT 5, INPUT 6, INPUT 7, INPUT 8, CAM 1, CAM 2, USB). Other actions are also possible such as adding the PUT 5, INPUT 6, INPUT 7, INPUT 8, CAM 1, CAM 2, USB). Other actions are also possible such as adding the
PID , deleting the added PID
In the second table "Deleted PID list", a few PID can be deleted from the output mux by entering the space
the PID to delete in the space, add it
INPUT 4, INPUT 5, INPUT 6, INPUT 7, INPUT 8, USB). Later the deleted PID can be reinstated
from the deleted PID list.
NOTE: CLICK ON "APPLY" TO SAVE THE DEFINITIVE CHANGES
By clicking on the "MUX Advanced Configurations" key, the following windows will appear:
The windows indicated in the figure 12 is used to set the following parameters:
• Time reference: to give a synchronization time reference by selecting INPUT 1, INPUT 2, INPUT 3, INPUT
4, USB). (e.g. time, EPG, etc.);
• Enabled LCN: after the checkbox selection is possible to enable or deactivate the LCN and then order the
programs according to their assigned priority;
• Auto SID Remapping: if enabled, this innovative function allows automatically assign a different SID to the
programs and it allows to change the output program list without tuning the channels of the TV;
• Auto program name: if enabled, this innovative function allows automatically assign a different program
name by entering it in the proper blink space (base name), e.g. program 1, program 2, etc.;
• Auto LCN: if enabled, this function allows to setup a base LCN number that is assigned to the first program
in the list, the following ones will then be set automatically in a sequence from the base number;
• LCN country: selects the country for comply the proper LCN ordering.
Original Network ID, Network ID, and the Private Data Specifying Descriptor are some "view only" advanced
signal parameter.
NOTE: CLICK ON "APPLY" TO SAVE THE DEFINITIVE CHANGES
, changing the added PID
to the list and select the relevant input (INPUT 1, INPUT 2, INPUT 3,
Fig.12
51
Operating instructions
and restoring the changed PID .
and removed