Fracarro D-Matrix 8T Instructions D'emploi page 49

Operating instructions
5.2.5 PROGRAM CONFIGURATION
The CONFIGURATION->PROGRAMS -> MUX 1 / MUX 2 / MUX 3 / MUX 4 / MUX 5 / MUX 6 / MUX 7 / MUX 8
menu allows to access the output Multiplex configuration page. The relevant parameters will be displayed:
Fig. 9
The left section shows the program list received from all the inputs, those one decrypted by the Professional
CAMS, plus the .TS file stored in a USB drive (if any).
The text box and the dropdown menus allow to filter the program lists for facilitating search. The easy mode
hides automatically the double program in the event of a decryption on CAM: if a program coming from an in-
put is added in decrypt, only the decrypted program will be shown. The programs which are not added in de-
crypt will always be shown. The advanced mode shows all programs regardless they are decrypted on CAM.
The input program columns show respectively:
the program name, the input the program comes from, the program type (TV, Radio, Data), if the received
program is free to air or encrypted, if decryption has been selected for one of the two CAMS and the band
used by the program (if the relevant box is flagged).
If the program is used to create one of the eight output mux, the box is automatically flagged and the relevant
bitrate is shown.
To add programs to an output multiplex, drag and drop the program name from the input list to the output list.
To do this, click the left button on the mouse over the program in the input program list, keep it pressed, drag
the program and then release it on the output mux required.
The OUTPUT columns displayed in the figure 9 show the following parameters:
the program name, the input the program comes from, the priority of the program (the lower the number the
higher the priority), the assigned LCN value (0 if not specified), the LCN HD and the bitrate used band.
The position (or priority) determines the importance of the programs and, therefore, which will be cut first if
there is a bitrate overflow, for example: 1 = top priority, therefore the most important program and the one to
save (see the paragraph Programming Indications).
The LCN and LCN HD parameters must be set so that each generated output program, including among a
number of devices, has a distinct value. If this is not to be specified, enter 0.
To remove a program from the output list click on X in the right hand column (ACTIONS).
49