Fracarro D-Matrix 8T Instructions D'emploi page 47

Operating instructions
Fig. 6 Fig. 7
The figure 6 shows the "COMMON INTERFACE MENU" page. The informations displayed are: the CAM mo-
dule information, the Smart Card infos and the last release of the CAM software.
The figure 7 shows the "ADVANCED SETTINGS" page: within this menu it's possibile to modify the advanced
CAM module functions. The items, CAPMT Management and CAPMT Sending, allow to change the different
CAM decrypt management by choosing from the options in the dropdown menu.
If the item CAPMT Resize is flagged, the CAM is set to decrypt just the program audio and video pids (in this
case, the number of decrypted programs could be higher). If it is not flagged everything is decrypted: audio,
video, ttx, subtitles, MHP, etc.
The item "CAPMT Resend Attempts" sets the number of decrypting attempts of a program that the CAM will
perform before starting again automatically; by default the value is 3.
The items "TS Framing" and "TS Clock" specify the transport streams CAM packages management (188 or
204 bytes) as well as which bitrate should be managed by the Professional CAM module. It's recommended
to modify the parameters above mentioned after checking the CAM technical specifications; the incorrect
setting can compromise the headend operation. The default parameters are normally suitable for the most of
the CAMs available on the market.
The "Time reference" section synchronizes the CAM with the information contained in the input programs. If
the CAM is set in AUTO, it will automatically search the various INPUTS time reference.
Click APPLY key and then OK key to save changes.
47