Fracarro D-Matrix 8T Instructions D'emploi page 34

To insert the Professional CAM modules in the C.I. slots, place the CAM module as shown in the figure and
press them lightly.
The CAMs module should freely slide along the C.I. guides. If it does not, check they are correctly aligned to
the insertion direction. To extract the Professional CAM modules pull slightly to one side and the CAM modu-
les should come out without difficulty.
The D-MATRIX 8T is equipped with eight multicolor LEDs on the top (two leds for each RF input) that monitor
the input signal reception status, and one multicolour led , located on the bottom side, that monitor the gene-
ral system status. Refer to the following table for an useful LEDs summary:
INPUT STATUS LED
Off: Input off
Orange: Input active waiting for lock
Green: Input active and locked
Red: Input current overloaded
SYSTEM STATUS LED (during initialization procedure)
Orange: Boot system
Red: Start applications
Green: System started without error
SYSTEM STATUS LED (system started)
Green: Normal
Orange: Anomaly
Flashing red: Update and/or recovery phase
3.3 CAM INSERTION PROCEDURE
3.4 MULTICOLOR STATUS LEDS
34