Input Menu; Power Supply - Fracarro D-Matrix 8T Instructions D'emploi

-
INPUT MENU: allows you to select one of the 9 inputs to be programmed (see the INPUT flow chart).
-INPUT 1, INPUT 2, INPUT 3, INPUT 4, INPUT 5, INPUT 6, INPUT 7 and INPUT8
LINK TO: 8 TV tuners are divided into four groups of two tuners each; each group can receive the signal
coming from the input connector or through the LOOP from the previous group. (For the INPUT 1 and 2,
the "LOOP" option is not possible as the signal must come from the Input CONNECTOR).
NOTE: using the LOOP option setting, just one input (the first one) can be used as the signal source for the
TV following tuners. For example, if we want to use just INPUT 1/2 and the LOOP is selected on all other
inputs, all these inputs will receive the signal coming from INPUT 1/2. In this case the only available signal is
in INPUT 1/2 and if there are any RF reception issue (i.e. RF discontinued signal, lock/unlock discontinued
condition) there could also be reception problems on all the modules with the LOOP inputs; in this case,
the LOOP option must be deactivated and the RF signal should be supply by connecting the RF cable di-
rectly to all the other input connectors.
ENABLE: enable the selected tuner connected to the relative TV input; if set in OFF status, the receiver
is turned OFF;
POWER SUPPLY: enable (ON) or disable (OFF) the remote power supply in order to supply the external
mast amplifier.
STANDARD: Selects the Input modulation standard: DVB-T or DVB-C.
TUNER DVB-T: DVB-T input signal parameters reception settings menu
SET BY FREQ.:
Bandwidht: sets the bandwidth of the input channel, 7 or 8 MHz.
Frequency (MHz): sets the input channel frequency.
SEL. BY CHANNEL:
Country: modifies the country (Europe, France, UK and Australia).
Channel in: sets the input channel you want to receive.
Offset: sets the frequency correction of the input channel;
HI/LO PRIORITY: allows setting the channel priority (High and Low);
TUNER DVB-C: allows setting the reception parameters of a DVB-C signal.
SET BY FREQ. (MHz): sets the MHz frequency of the input channel.
SELECT BY CHANNEL:
Country: select the country (Europe, France, UK and Australia).
Channel in: sets the input channel you want to receive.
Offset: sets the offset frequency correction of the input channel;
FLOW CHART INPUT
36