Use Instructions - Frigelux Rc265Bf Manuel D'utilisation

1. Carrefully remove the top hinge cover with a flat screw driver.
2. Unscrew the top hinge with a screw driver.
3. Remove the hole cover with a flat screw driver.
4. Move the core cover from left side to right side. And then lift the upper door and place it on a
padded surface to prevent it from scratching.
5. Unscrew the middle hinge and then lift the bottom door and put it on a soft pad to avoid
scratch.
6. Move two middle hole covers from left to right.
7. Lie down the rear of cabinet on a soft pad. Unscrew the bottom hinge and leveling foot.
8. Unscrew and remove the bottom hinge pin, turn the bracket over and replace it.
9. Install the hinge at left side and foot base at right side. Then screw two leveling feet with their
original parts.
10. Move two middle hole covers from left to right.
11. Stand up the unit and put the door on the bottom hinge. Make sure the bottom hinge core is
inserted in the door hole. Then move the hinge cover of bottom door from left side to right
side.
12. Install the middle hinge.
13. Install the upper door with the upper hinge.
14. Clap in the hinge cover and hole cover on the top of unit.
15. Check whether the door gasket is deformed. If yes, detach the fridge and the freezer door
gaskets and then attach them after rotating.

4. USE INSTRUCTIONS

Temperature setting:
Your refrigerator has one control for regulating the temperature. The temperature control is located at
the top of the fridge.
The first time you put your appliance into operation, set the thermostat to "MED" (4 to 5) and let it run
26