Before plugging in
Check that you have a socket which is compatible with the plug supplied with the appliance.
DO NOT SWITCH ON, UNTIL FOUR HOURS AFTER MOVING THE APPLIANCE.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30
minutes before switching back on to allow the coolant fluid to settle.
Before filling your appliance
Before storing food in your appliance, turn it on and wait for 24 hours, to make sure it is
working properly and to allow it to reach the correct temperature.
4.
USE INSTRUCTIONS
Temperature setting :
Your refrigerator has one control for regulating the temperature. The temperature control
is located at the top of the fridge.
The first time you put your appliance into operation, set the
thermostat to "MED" (4 to 5) and let it run
empty for 4 hours before storing food for it to cool sufficiently.
The range of temperature control is from position "1" the warmest
to "7" the coldest. Adjust the temperature control to the setting that
best suits your needs. The setting of "MED" should be appropriate
for home or office refrigerator use.
To turn the refrigerator off, turn the temperature control to "0.
Appliance thermostat has 7 settings. The appliance assures that temperature is
maintained as long as it is in operation and that it is used in normal conditions of use. The
temperature inside the appliance can be influenced by many factors : ambient
temperature, sun exposure, number of door opening and amount of food stored... The
slight changes in temperature are perfectly normal.
•
Setting 0 : OFF
Setting "MIN"(Settings 1 to 3) : Refrigerator compartment average
•
temperature 4 to 10°C ; Freezer compartment average temperature -10 to -16°C
Setting "NORMAL" (Settings 4 to 5) : Refrigerator compartment average
•
temperature 0 to 8°C ; Freezer compartment average temperature -14 to -20°C
Setting "MAX" (Settings 6 to 7) : Refrigerator compartment average
•
temperature -3 to 3°C ; Freezer compartment average temperature -18 to -22°C
NOTE :
▪ Turning the thermostat to "0" stops the cooling cycle but does not stop power to the
appliance.
▪ If the unit is unplugged, lost power, or turned off; you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the appliance will
not start.
▪ If you choose to change the thermostat setting, adjust thermostat control by one
numerical increment at a time. Allow several hours for temperature to stabilize
between adjustments.
Do not leave the door open for too long so that the indoor temperature does not rise
too much.
28