Frigelux RC265WDBES Manuel D'instructions page 36

1. Carefully remove the top hinge cover with a flat screwdriver.
2. Unscrew the top hinge with a screwdriver.
3. Remove the hole cover with a flat screwdriver.
4. Move the core cover from left side to right side. And then lift the upper door and
place it on a padded surface to prevent it from scratching.
5. Unscrew the middle hinge and then lift the bottom door and put it on a soft pad to
avoid scratch.
6. Move two middle hole covers from left to right.
7. Lie down the rear of the cabinet on a soft pad. Unscrew the bottom hinge and level
foot.
8. Unscrew and remove the bottom hinge pin, turn the bracket over and replace it.
9. Install the hinge at left side and foot base at right side. Then screw two leveling feet
with their original parts.
10. Move two middle hole covers from left to right.
11. Stand up the unit and put the door on the bottom hinge. Make sure the bottom hinge
core is inserted in the door hole. Then move the hinge cover of the bottom door from
left side to right side.
12. Install the middle hinge.
13. Install the upper door with the upper hinge.
14. Clap in the hinge cover and hole cover on the top of unit.
Check whether the door gasket is deformed. If yes, detach the fridge and the freezer door
gaskets and then attach them after rotating.
Handle installation
36