Frigelux RC265WDBES Manuel D'instructions page 34

Moving the unit
▪ Location
Do not place your appliance near a heat source, for example stove, boiler or radiator. Also,
avoid direct sunlight.
▪ Leveling
Make sure the appliance is level. Use the adjustable feet at the front. If the appliance is not
level, the doors and magnetic sealing alignments will be affected and may cause
malfunctions.
▪ Do not turn on the appliance for 4 hours
After any movement, it must not be connected for 4 hours. This delay allows the coolant to
be adjusted.
▪ Installation
Let your device breathe. Heat is released from the walls, so it is important to leave a
circulation of air around your device.
Energy saving tips
▪ The appliance should be located in the coolest area of the room, away from heat
producing appliances or heating ducts, and out of the direct sunlight.
▪ Let hot foods cool to room temperature before placing them inside. An overload will
force the compressor to run longer. Food that freezes too slowly may lose quality or
deteriorate.
▪ Be sure to wrap food properly, and wipe containers dry before placing them in the
appliance. This cuts down on frost build-up inside.
▪ Storage bins should not be lined with aluminum foil, wax paper, or paper toweling.
Liners interfere with cold air circulation, making the appliance less efficient.
▪ Organize and label food to reduce door openings and extended searches. Remove
as many items as needed at one time and close the door as soon as possible.
Changing the light bulb
This appliance consists of light-emitting diodes (LEDs). This type of
diode cannot be changed by the consumer. The lifetime of these LEDs
is normally sufficient for no change to be made. If however, and
despite all the care taken during the manufacture of your appliance,
the LEDs were defective, please contact your after-sales service for
any intervention.
Reverse door
Depending on your needs, you can change the opening side of the door. You can choose
to open it from the right or from the left. To change the opening side, follow the instructions.
Warning:
• Before changing the opening side of the door, unplug the device from the mains.
• Any removed part must be kept until the end of installation.
• Do not lay the device down on the floor, you could damage the cooling system.
34