Télécharger Imprimer la page

Parkside Performance PPAHS 40-Li A1 Mode D'emploi page 44

Publicité

To replace the stop protection 
or in case of damage to the hand
protection 
, contact our Service
[
3 ]
entre see "Service"
˜ Inserting and removing the
battery packs
WARNING! Risk of injury due to
m
unintentional start-up!
Only insert the battery packs 
u
once the product is fully prepared
for use.
NOTICE! Risk of property
m
damage and damage to the
product!
An incorrect battery pack can
u
damage the product and the
battery pack.
Inserting the battery packs
Push both battery packs 
o
the guide into the battery pack
holder 
. You hear the battery
6 ]
[
packs click into place.
Removing the battery packs
1. Press and hold the release button 
on the battery packs 
2. Pull the battery packs 
battery pack holder 
˜ Setting the stroke rate
Press the
 button 
o
stroke rate.
The relation between the digits 1/ /
 
on the level display 
rate per minute is shown in the
following table:
Level
1
42 GB/IE
[
1 ]
[
9 ]
along
[
9 ]
[
.
9 ]
[
out of the
[
9 ]
.
[
6 ]
to set the
[
]
and the stroke
[
]
Stroke rate
2 000 min
–1
000 min
–1
00 min
–1
˜ S i
i
ig  B
NOTE
You can only operate the product
u
ith 2 battery packs 
Before switching on the product:
u
Remove the blade encasing 
from the safety cutter bar 
Do not lock the on o s itch 
u
and the safety s itch 
motor must s itch o hen you
release the switches.
Switching on
CAUTION! Risk of personal injury
m
and damage to the product!
Ensure your stance is stable and
u
hold the product tightly with both
hands and away from your body.
NOTICE! Risk of property
m
damage and damage to the
product!
Before switching on the product:
u
Make sure that the product is not
]
touching any objects.
1. Insert the battery packs 
2. Remove the blade encasing 
3. Always hold the product with both
hands One hand on the handle 
and the other hand on the front
handle 
.
[
4 ]
4. Press and hold the safety s itch 
on the front handle 
pressing the on o s itch 
handle 
.
8 ]
[
5. The product runs at the lowest speed
(Setting the speed: see "Setting the
stroke rate"
/
.
9 ]
[
[
]
.
2 ]
[
[
7 ]
. The
[
]
.
9 ]
[
.
[
]
8 ]
[
[
while
4 ]
[
on the
[
7 ]
]

Publicité

loading

Ce manuel est également adapté pour:

472001 2407