Disposal - Parkside Performance Ppahs 40-Li A1 Mode D'emploi

Problem
The safety cutter
bar becomes
2 ] [
hot.
Bad cutting result
˜ Disposal
The packaging is made entirely of
recyclable materials, which you may
dispose of at local recycling facilities.
Observe the marking of the
packaging materials for waste
separation, which are marked
ith abbreviations a and
numbers b ith follo ing
meaning: 1–7: plastics/20–22:
paper and breboard 0 9
composite materials.
P
46 GB/IE
Possible cause
The safety cutter bar
blunt.
There are nicks on the safety
cutter bar .
2 ] [
Too much friction due to lack
of lubrication
Too much friction due to lack
of lubrication
The safety cutter bar
blunt.
The safety cutter bar
dirty.
Bad cutting technique
Solution
is ave the safety cutter bar
2 ] [
sharpened or replaced.
Contact our Service Centre
see "Service"
Lubricate the safety cutter
bar .
[ 2 ]
Lubricate the safety cutter
bar .
[ 2 ]
is ave the safety cutter bar
2 ] [
sharpened or replaced.
Contact our Service Centre
see "Service"
is lean the safety cutter bar
[ 2 ]
see " leaning"
see "Cutting techniques"
The product incl. accessories and
packaging materials are recyclable
and are subject to extended producer
responsibility.
Dispose them separately, following the
illustrated Info tri sorting information
for better waste treatment.
The Triman logo is valid in France only.
Contact your local refuse
disposal authority for more
details of how to dispose of
your worn-out product.
To help protect the environment,
please dispose of the product
properly when it has reached
the end of its useful life and
not in the household waste.
Information on collection points
and their opening hours can
be obtained from your local
authority.
2 ] [
2 ] [
2 ] [