Charging The Battery Pack; Operation; Working With The Product - Parkside Performance Ppahs 40-Li A1 Mode D'emploi

The charging level of the battery
pack is indicated by illumination
9 ] [
of the corresponding LED lights on
the charging level indicator
Indicator Colour
Red,
orange,
green
Red,
orange
Red
harge the battery pack
o
only the red LED on the charging
level indicator
[
˜ Charging the battery pack
NOTICE! Risk of damage to the
m
9 ] [
Do not e pose the battery pack
u
to direct sunlight for long periods
and do not place it on a radiator.
Observe an ambient temperature
of ma 0
NOTE
You can nd detailed instructions
u
in the user manual of the
charger .
[ ]
If the battery pack
u
allow it to cool down before
charging.
1. Remove the battery pack
product.
2. Push the battery pack
charging slot of the charger
3. onnect the charger
outlet.
4. After charging: Disconnect the
charger from the socket-outlet.
[ ]
40 GB/IE
.
[ ]
Meaning
Fully
charged
Partially
charged
Needs to
be charged
when
[ 9 ]
is illuminated.
]
!
[ 9 ]
is still warm,
9 ] [
from the
9 ] [
into the
9 ] [
.
[ ]
to a socket-
[ ]
5. Pull the battery pack
charger .
[ ]
C LED
Green Red
Lights —
up
— Lights
up
— Flashes
Flashes Flashes
˜ Operation
˜ Working with the product
WARNING! Risk of injury!
m
Pay attention to the following
u
instructions.
NOTICE! Risk of damage to the
m
While cutting, make sure that you
u
do not touch any objects, such as
wire fences or plant supports.
Always wear sturdy shoes, long
trousers, ear protection, work
gloves and protective goggles when
operating the product.
The product is only intended for
work where you are standing on the
ground and not on a ladder or other
unstable surface.
Do not use the product if the on o
s itch or the safety s itch
[ 7 ]
damaged.
out of the
[ 9 ]
[ ]
Meaning
Fully charged
Stand-by mode
(no battery
pack i nserted
[ 9 ]
Charging
Battery pack
[ 9 ]
is overheated
Battery pack
[ 9 ]
is defective
!
2 ] [
is
[ ]