Before First Use; Unpacking The Product; Preparation; Wall Holder - Parkside Performance Pphsa 40-Li C3 Instructions De Montage, D'utilisation Et Consignes De Sécurité

˜ Before first use
˜ Unpacking the product
1. Take the product out of the packaging and
remove all packaging materials and plastic
wrappings.
2. Check to make sure that all listed parts are
included (see "Scope of delivery").
3. Check whether the product and all parts
are in good condition, if any damage or
defect is detected, do not use the product,
but follow the procedure described in
chapter "Warranty".
˜ Preparation
m WARNING! Risk of injury due to
unintentional start-up!
Only insert the battery packs
u
the product is fully prepared for use.
˜ Wall holder
(Fig. E)
You can hang the motor part on a wall
o
with the keyhole
[
product.
Tools and aids required
Screw (screw head: Ø 8‒10 mm)
o
Corresponding screwdriver
o
Dowel
o
Attaching the wall holder
m WARNING! Risk of personal
injury or damage to property
during drilling!
Use a suitable detector to determine if
u
there are hidden supply lines or contact
the local utility company for assistance.
Contact with electric cables can cause
fire and electric shock. Damaging gas
lines can lead to explosion. Breaking
water pipes causes property damage.
38 GB/IE
once
9 ] [
on the bottom of the
]
1. Drill a hole into the wall at the desired
location.
2. Insert a dowel into the hole.
3. Let the screw head protrude approx. 10 mm
from the wall.
4. Make sure that the wall and screw can
withstand the weight of the product.
5. Place the keyhole
the product down as far as it will go.
˜ Attaching/removing the
clippings collector
Attaching: Slide the clippings
o
collector with the angled edge onto the
[ ]
safety cutter bar
2 ] [
Removing: Pull the clippings collector
o
forwards off the safety cutter bar
˜ Checking the charging level
of the battery pack
Press the button
o
level indicator
[ ]
The charging level of the battery pack
o
is indicated by illumination of the
corresponding LED lights on the charging
level indicator
.
[ ]
Indicator Colour
Red, orange,
green
Red, orange
Red
Charge the battery pack
o
red LED on the charging level indicator
is illuminated.
on the screw and pull
[ ]
.
.
2 ] [
next to the charging
[ ]
on the battery pack
[ 9 ]
[ 9 ]
Meaning
Fully charged
Partially
charged
Needs to be
charged
when only the
[ 9 ]
[
[ ]
.
]