Troubleshooting - Parkside Performance Pphsa 40-Li C3 Instructions De Montage, D'utilisation Et Consignes De Sécurité

˜ Troubleshooting
Problem
The product does not
start.
The product works
with interruptions.
The safety cutter
bar becomes hot.
2 ] [
Bad cutting result
44 GB/IE
Possible cause
The battery packs
[ 9 ]
inserted.
The battery packs
[ 9 ]
discharged.
The on/off switch or the safety
[ 7 ]
switch is defective.
[ ]
The motor is defective.
Internal loose contact
The on/off switch or the safety
7 ] [
switch is defective.
[ ]
The safety cutter bar
[ 2 ]
There are nicks on the safety cutter
bar .
[ 2 ]
Too much friction due to lack of
lubrication
Too much friction due to lack of
lubrication
The safety cutter bar
2 ] [
The safety cutter bar
2 ] [
Bad cutting technique
Solution
are not Insert the battery packs
"Inserting and removing the
battery packs").
are Charge the battery packs
"Charging the battery pack").
Contact our Service Centre (see
"Service").
Contact our Service Centre (see
"Service").
is blunt. Have the safety cutter bar
sharpened or replaced.
Contact our Service Centre (see
"Service").
Lubricate the safety cutter bar
Lubricate the safety cutter bar
is blunt. Have the safety cutter bar
sharpened or replaced.
Contact our Service Centre (see
"Service").
is dirty. Clean the safety cutter bar
(see "Cleaning").
see "Cutting techniques"
(see
9 ] [
(see
9 ] [
2 ] [
.
[ 2 ]
.
2 ] [
[ 2 ]
2 ] [