Scheppach SG1600i Traduction Des Instructions D'origine page 28

16. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Generator does not
start
Generator has
insu昀케cient or no
voltage
28 | GB
Possible cause
Automatic oil cut-o昀昀 starts
Spark plug sooty
No fuel
Electronics defective
Overload protection switch
tripped
Air 昀椀lter dirty.
www.scheppach.com
Remedy
Check oil level, 昀椀ll with engine oil as necessary.
Clean or replace spark plug.
Check electrode gap.
Top up with fuel.
Check fuel tap function.
Contact the specialist dealer
Restart generator.
Reduce consumption
Clean or replace 昀椀lter if necessary.