3.5 To operate the product
Warning! The product have an electric brake
system. If the product do not stop quickly after the power
trigger is released, have the product examined by a
qualified personnel.
Caution! Use the applicable saw blade for the
material to be cut.
Caution! Make sure that the saw blade is correctly
installed and locked before you operate the product.
Caution! If the saw blade get caught, release the
power trigger immediately, stop the product and remove
the battery. Widen the saw gap with a tool and pull the
blade out.
Note! Do not use force on the product. Put the base plate
tightly against the surface when you cut. Apply sufficient
pressure for the blade to work through the workpiece.
Decrease the pressure when the blade comes near the
end of the cut.
Note! The material gets hot along the cutting line when
you cut metal. Apply coolant or lubricant to prevent
damage to the saw blade and the workpiece.
3.5.1 To start the product
Figure 6
1
Push the power switch lock to unlock (A).
2
Push the power trigger to start the product (B).
3
Let the product reach maximum stroke rate before
you put the saw blade into contact with the
workpiece.
Note! Increase the pressure on the power trigger for a
higher stroke rate and decrease for a lower stroke rate.
● Adjust the stroke rate to the workpiece to be cut. Use a
low stroke rate for hard materials, for example metal
and high stroke rate for softer material.
3.5.2 To stop the product
1
Release the power trigger.
2
Push the power switch to lock.
3.6 To adjust the hanging hook
Caution! Do not transport the product by hanging
it in your belt.
Caution! Do not hang the product on surfaces that
are not stable, for example on ladders.
● The hanging hook can be adjusted in 3 different
lockable positions. (Figure 7)
4
Transport
● Let the product come to a complete stop and remove
the battery before you transport the product.
● Use the handle when you lift or move the product.
5
Storage
● If the product is not going to be used for a long period
of time, remove the battery, keep the product in a
clean and dry area, where children and pets do not
have access to it.
6
Maintenance
Warning! The power tool must only be serviced by
qualified personnel using identical spare parts. This will
make sure that the power tool remains safe to use.
Warning! Stop the product and remove the battery
before you do any maintenance or clean the product.
6.1
To clean the product
Caution! To prevent damage to the surface of
the product, do not use harsh detergents or abrasive
cleaners.
● Clean the product with a damp cloth regularly. Make
sure that the air outlets are not blocked from debris.
7
Discard
● Make sure that you follow local regulations when you
discard the product. Do not burn the product.
EN
SV
NO
DA
PL
DE
FI
FR
NL
11