Dab Basic Operations - Teac AG-H600NT Mode D'emploi

Setting up your DAB Tuner
The first time you select DAB as the source, the unit will scan for DAB
channels and build a channel list.
2
1
1 Press the power switch to turn the unit on.
< When the system control functions are activated, always set this
switch on, and turn the unit on/standby using the remote control
unit.
Select DAB by pressing the SOURCE button repeatedly.
2
< You can also use the BAND button on the remote control unit.
The unit will scan for ensembles broadcast in the local area and
add them to the channel list as they are found. The scan should
take about 20 seconds.
Scanning...
209.93MHz
After broadcast services have been found the channels are listed
in alphanumeric order.
< If no broadcast services are found, please check that the antenna
is correctly connected to the unit.
16

DAB Basic Operations

Using the Channel List
Select DAB by pressing the SOURCE button repeatedly.
1
< You can also use the BAND button on the remote control unit.
The list of available channels is displayed.
< If the channel list is not displayed, turn the MULTI JOG/ENTER
knob or press the skip buttons (.//) on the remote control
unit.
2 Scroll through the channels in the channel list.
Turn the MULTI JOG/ENTER knob.
When you have found a channel that you want to listen to,
3
press the ENTER button.
The channel is tuned in and channel information is displayed.
1
2 3
BBC Radio 1
BBC Radio 1Xtra
Selecting...
BBC 6
Jazz festival on