Operations; Listening To A Program Source - Teac AG-980 Manuel Du Propriétaire

Operations

LISTENING TO A PROGRAM SOURCE

Before operation
• Push the POWER switch.
.
1
In the standby mode, turn the power on.
.
2
Switch the desired speakers on.
• This unit enters the standby mode and the STANDBY indi-
cator lights up.
This means that the receiver is not disconnected from the
AC mains and a small amount of current is retained to sup-
port the operation readiness.
• To switch the power off, push the POWER switch again. Then
the power is cut off and the STANDBY indicator turns off.
• Each time the STANDBY/ON button on the front panel, the
receiver is turned on to enter the operating mode or off to
enter the standby mode.
• On the remote control, press the ON button to enter the
operating mode or press the STANDBY button to enter the
standby mode.
• You can select the various combinations of speakers
depending on where the speakers C or/ and D are installed.
• Each time the MAIN ZONE SPEAKER (A/B) SELECTOR
button is pressed, the speakers are switched on or off as fol-
lows :
A/B ~ - / - ~
or (MAIN A/B) or (MAIN -/-)
( ) : When the SUB ZONE mode is set to on.
• Each time the SUB ZONE SPEAKER (C/D) SELECTOR
button is pressed, the speakers are switched on or off as fol-
lows :
~ C/D ~ - / -
or (R2 C/D) or (R2 -/-)
( ) : When the SUB ZONE mode is set to on.
• When using the headphones for private listening, switch off
all the speakers installed in the main room.
∑Note :
• To use SUB ZONE function, you should install speakers C
or/and D in another room (SUB ZONE) and set the SUB
ZONE mode to on. (For details, refer to "CONNECTING
SPEAKERS" on page 6 and "SUB ZONE PLAYBACK" on
page 21.)
10
A/ - ~ - /B ~
or (MAIN A/-) or (MAIN -/B)
~ C/ - ~ - /D
or (R2 C/-) or (R2 -/D)