Teac AG-H600NT Mode D'emploi page 7

A LINE IN/OUT jacks
These jacks transmit an analog 2-channel audio signal. Connect
the components using RCA cables.
< Make sure to connect the cables as follows:
white plug q white jack (L: left channel)
red plug q red jack (R: right channel)
White (L)
Red (R)
< Be sure to insert each plug securely. To prevent hum and noise,
avoid bundling the cables together with the AC power cord or
speaker cables.
B PHONO jacks
Connect the turntable's RCA pin cord to the PHONO jacks.
< Make sure to connect the cables as follows:
white plug q white jack (L: left channel)
red plug q red jack (R: right channel)
< Be sure to insert each plug securely. To prevent hum and noise,
avoid bundling the cables together with the AC power cord or
speaker cables.
C SIGNAL GND
To prevent hum and noise, connect the ground lead of the
turntable to this terminal.
< This is not a safety earth.
D AC Inlet
Use only the supplied power cord.
< Use of other power cord may result in fire or electric shock.
< Unplug the power cord when you are not going to use the unit
for an extended period of time.
E iPod dock port
Connect the iPod dock (option) to this port.
< Make sure the label A side of the plug is up.
< Securely insert the plug until a slight "click" is heard.
To disconnect the dock
Push the buttons of the plug and pull.
White (L)
Red (R)
Compatible iPod Software
If your iPod does not work with the unit or with the remote
control unit, software update may solve the problem. Visit the
Apple web site and download the latest iPod Software.
F VIDEO OUT terminal
This terminal outputs video signal from iPod. Use a composite
video cable to connect the dock to the composite video
connector of a television or monitor.
G S-VIDEO OUT terminal
This terminal outputs S-video signal from iPod. Use an S-video
cable to connect the dock to the S-video input of a suitably
equipped television or monitor. Use this connection in
preference to a composite video connection.
label
7