Adjusting Bass, Midrange, Treble, Balance Of Speakers - Teac AG-H600NT Mode D'emploi

Adjusting Bass, Midrange, Treble, Balance of Speakers, and DIMMER
1 Select the item to adjust.
Each time you press the VOLUME/SET knob, the display changes
as follows:
VOLUME (volume)
TREBLE
BALANCE
DIMMER
< You can also use the SET button on the remote cntrol unit.
BASS
Adjusts the level of low frequency sound range. The level can
be adjusted from –12 to +12.
MID
Adjusts the level of middle frequency sound range. The level
can be adjusted from –12 to +12.
TREBLE
Adjusts the level of high frequency sound range. The level can
be adjusted from –12 to +12.
BALANCE
Adjusts the balance of the volume level between left and right
speakers.
DIMMER
Adjusts the dimming level of the display in 3 levels.
1 2
BASS
MID
< You can also use the DIMMER button of the remote control unit.
Each time you press the DIMMER button, the display changes
as follows:
NORMAL (Normal)
DIMMER (Dimmed)
LIGHT OFF (Display off)
< This setting is not memorized when the unit turns into standby.
The next time the unit is turned on, the display is illuminated as
normal.
< When the unit is operated during the setting is "LIGHT OFF", the
display turns normal briefly and will turn off again.
Turn the VOLUME/SET knob to change the setting.
2
< You can also use the VOLUME buttons (+/–) on the remote cntrol
unit.
3 Leave the unit idle for 3 seconds to exit the setup mode.
Tone Direct
Press the TONE DIRECT button to cancel the tone adjustments
temporarily.
When this function gets active, the Tone Direct indicator lights
up temporarily.
FM
CH01
< To cancel the Tone Direct function, press the button again.
< When this function is active and no operation is done for about
5 seconds, the display is turned off regardless of the dimmer
setting.
Tone Direct indicator
98.1MHz
13