Teac AG-H600NT Mode D'emploi page 18

Channel Scan
If you move the unit to a new area or you want to check to see if
there are new channels available in your area, you can scan DAB
bands to find new channels.
1 Open the DAB menu.
Press the MENU button while DAB is selected as the source.
Station List
Local Scan
2 Select "Local Scan" or "Full Scan".
Turn the MULTI JOG/ENTER knob to select the item, and then
press the MULTI JOG/ENTER knob.
Local Scan
The unit will scan the DAB bands between 10A and 13F and add
the channels found to the channel list.
Full Scan
The unit will scan all the DAB bands and add the channels
found to the channel list. Try this if "Local Scan" does not find
the channels you want.
Manual Tune
The signal strength is displayed. This may be useful when
adjusting or positioning an antenna for better reception.
1 Open the DAB menu.
Press the MENU button while DAB is selected as the source.
Station List
Local Scan
18
Using DAB Menu (2)
2 Select "Manual Tune".
Turn the MULTI JOG/ENTER knob to select the item, and then
press the MULTI JOG/ENTER knob.
Select the channel you want to tune in.
3
Turn the MULTI JOG/ENTER knob to select the item, and then
press the MULTI JOG/ENTER knob.
The signal strength indicator is displayed.
While viewing the indicator, adjust or reposition the
4
antenna until the best reception is indicated.
DRC value
This option sets the Dynamic Range Control (DRC) value to be
applied to received broadcasts. DRC is used to reduce the range
between high and low volumes of audio and is sometimes applied
at the broadcast source. Pop music may have a high value of DRC
applied, appropriate for constantly high listening levels, while
classical music broadcasts may have no DRC applied to allow the
listener to hear the full dynamic range of the source volume.
Open the DAB menu.
1
Press the MENU button while DAB is selected as the source.
Full Scan
Manual Tune
5A 174.92MHz
Station List
Local Scan