Setting The Main Display; Setting The Additional Display - WIKA DMSU21SA Mode D'emploi

6. Display and operating unit

6.4 Setting the main display

The main display can indicate the following values:
Pressure
■
Level
■
Volume
■
Current
■
PV percent
■
Sensor temperature Temperature at the sensor is displayed.
■
PV (primary value) The value corresponding to the mode will be displayed.
■
1. Open the operating menu with [↵].
Select "Display" and confirm with [↵].
2. Select "Main display" and confirm with [↵].
3. Select value and confirm with [↵].
» Main display indicates the selected value.

6.5 Setting the additional display

The additional display can indicate the following values:
Measured values
Pressure
■
Level
■
Volume
■
Current
■
PV percent
■
Sensor temperature Temperature at the sensor is displayed.
■
PV (primary value) The value corresponding to the mode will be displayed.
■
WIKA operating instructions, model DMSU21A
Applied pressure is displayed.
Level is displayed.
Volume is displayed.
Output signal is displayed.
Output signal is displayed as a percentage.
If the mode is changed, then the main display will change.
Applied pressure is displayed.
Level is displayed.
Volume is displayed.
Output signal is displayed.
Output signal is displayed as a percentage.
If the mode is changed, then the main display will change.
EN
25