Transport, Packaging And Storage; Transport; Packaging; Storage - WIKA DMSU21SA Mode D'emploi

4. Transport, packaging and storage

4. Transport, packaging and storage

4.1 Transport

Check the diaphragm monitoring system for any damage that may have been caused by
transport. The display of the monitoring element must be located in the green area.
Obvious damage must be reported immediately.

4.2 Packaging

Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change in
installation site, return for calibration).

4.3 Storage

Permissible conditions at the place of storage:
Storage temperature: -40 ... +80 °C [-40 ... +176 °F]
■
Avoid exposure to the following factors:
Proximity to hot objects, when permissible storage temperature is exceeded by
■
radiation.
Mechanical vibration, mechanical shock (putting it down hard), when the permissible
■
values are exceeded, see chapter 15 "specifications".
Soot, vapour, dust and corrosive gases.
■
Hazardous areas and flammable atmospheres where the instruments are not suitable
■
for installation in or mounting to equipment in explosive atmospheres.
Store the diaphragm monitoring system in its original packaging in a location that fulfils
the conditions listed above. If the original packaging is not available, then store the
instrument in a container that is similar to the original packaging, so that the instrument
can't be scratched and is protected against damage if dropped.
WIKA operating instructions, model DMSU21A
EN
17