Siemens Synco 700 Manuel D'utilisation page 45

Entering additional switching points
1. Select the required day.
2. In the diagram, advance pointer
in time of the current program.
3. Turn the OK knob by one notch;
–––––– appears.
––:––
4. Set the required start time.
5. Select the required room operating mode.
Copying a time program within the same week
1. Select the day to be copied.
2. Turn the OK knob in clockwise direction until Copy to:
appears.
3. Press the OK knob.
4. The menu with the selection of days (week section,
individual weekdays, special day) appears.
5. Select the required weekday or week section.
6. Copy (press the OK knob).
First, prepare a 7-day schedule for the daily switching times and operating modes – this will facilitate
Siemens Building Technologies / HVAC Products
to the last point
entry into the central control unit!
CE1B3121x2-en
Copying a time program to other room groups
1. Select the day to be copied.
2. Turn the OK knob in clockwise direction until Copy to:
appears.
3. Press the OK knob.
4. The menu for selection of the room groups (All room
groups, Room group 1...10) appears.
5. Select the required room group.
6. Copy (press the OK knob).
New 24-hour program
The central control unit is supplied with a 24-hour pro-
gram entered for every day (incl. special day). This
means that you never have to create a new 24-hour
program, but only change an existing program.
Power off – heating / cooling program lost?
In the event of a power failure, the 24-hour programs
entered will be maintained, independent of the duration
of the power failure.
74 319 0462 0 a
17
15.04.2005