A Fault Has Occurred - Siemens Synco 700 Manuel D'utilisation

A fault has occurred

If a fault occurred in the plant, it will appear on the dis-
play. In addition, the LED inside the
will be on. Proceed as follows
LED flashes:
1. Press the button to unlock.
2. If the LED keeps flashing, the fault still exists or the
button must be pressed again to unlock.
LED lit:
1. Rectify the fault.
2. If the LED is still lit, the
again to unlock.
Unlocking is possible only after the cause of fault has
been removed.
If you cannot rectify the fault, contact your HVAC engi-
neer.
Siemens Building Technologies / HVAC Products
button will flash or
button must be pressed
Path: Welcome > Main menu > Faults...
Additional information about the display of faults:
Faults current menu
Here, you can see which faults are currently present.
The following information about each fault is displayed:
• The cause (e.g. pump 1)
• The error code (important for the HVAC engineer)
• The date and the time of day the fault occurred
Fault history menu
Here, each of the last 10 faults will be listed. The infor-
mation given is the same as that provided with current
faults.
Fault status message bus menu
If your plant contains several interconnected devises, the
central control unit will display faults of other devices.
Fault indication on the setting level
If you keep the ESC button depressed for 2 seconds, the
current fault will be displayed.
CE1B3121x2-en 74 319 0462 0 a
23
15.04.2005