Ryobi ONE+ PBL375 Manuel D'utilisation page 10

LED WORKLIGHT
See Figure 9, page 13.
Press the grip switch while firmly holding tool to activate
the worklight.
DIAGNOSTIC FEEDBACK
The LED worklight provides feedback to indicate whether
the battery pack is charged sufficiently and/or if the tool is
functioning properly.
If worklight is flashing slowly and continuously, install fully
charged battery. If light continues to flash, see the Trouble-
shooting section for more information.
REMOVING NAILS FROM THE TOOL
See Figure 10, page 13.
WARNING:
Remove the battery pack before removing nails or
clearing a jammed nail. Failure to do so could result in
serious personal injury.
„ Remove the battery pack.
„ To remove a strip of nails from the tool, press the release
button on the pusher, and guide it to the front of the
magazine. When released, the nails will be released.
NOTE: Always keep fingers clear of nail track of magazine
to prevent injury from unintended release of the pusher.
„ Slide the nails toward the back of the magazine and
remove.
WARNING!
Always point the tool away from yourself and others when
removing fasteners. Failure to do so could result in seri-
ous personal injury.
OPERATION
REMOVING A JAMMED NAIL
See Figures 11 - 13, page 13.
WARNING:
Always point the tool away from yourself and others when
removing a jammed nail. Failure to do so could result in
serious personal injury.
WARNING:
Never place a hand or any part of body in fastener dis-
charge area of tool when removing a jammed nail. Failure
to do so could result in serious personal injury.
Driving too deeply into the material, excess debris, or jammed
nails may lead to the driver mechanism being stuck at its
bottom position.
The driver mechanism can usually be returned to its operat-
ing position by depressing the workpiece contact against a
scrap piece of wood and squeezing the trigger.
If this does not automatically return the driver mechanism
into the tool, the tool may be jammed.
If a nail or fastener becomes jammed in the tool, remove
the battery pack, and keep the tool pointed away from you
while clearing the jam.
„ Remove the battery pack from the tool.
„ To remove a strip of nails from the tool, press the release
button on the pusher, and guide it to the front of the
magazine. When released, the nails will be released.
„ Slide the nails toward the rear of the magazine, past the
nail stop plate, and remove the nails from the magazine.
NOTE: Always keep fingers clear of nail track of magazine
to prevent injury from unintended release of the pusher.
„ Pull up on the latch, and undo the jam release hook. Open
the jam release.
„ Remove the bent nail.
„ Close the jam release and latch.
„ Reinstall nails.
„ Reinstall battery and activate the tool by pressing the
worklight grip switch.
NOTE: Do not attempt to manually retract the drive
mechanism. This may cause damage to the tool and
can be unsafe.
10 — English