Saeco Talea Touch Plus RI9828/11 Mode D'emploi page 32

To manage the different procedures correctly, the machine could need the knob to be turned on (ref.
(ref. ) during the different steps. When needed, turn the knob as indicated on the display.
4
fi ll the water tank with the
descaling solution
When the above message appears,
the boiler is at the right
temperature.
7
boiler descaling cycle
The machine begins to dispense the
descaling solution through the hot
water / steam wand. The dispensing
occurs at predetermined intervals, in
order to allow the solution to settle.
5
Pour the entire content of the Saeco
concentrated descaling solution into
the water tank, and then fi ll the tank
with fresh drinking water up to the
MAX level.
Place the tank back into the
machine.
8
boiler descaling cycle
The intervals are displayed as shown
above in order to check the progress
of the descaling cycle.
29
) or off
6
fi ll the water tank with the
descaling solution
Press the key to start.
When the solution is fi nished the
following message appears on the
display:
9
fi ll water tank
Remove the water tank, rinse
with fresh drinking water to
eliminate traces of the descaling
solution, then refi ll with fresh
drinking water.