Saeco Talea Touch Plus RI9828/11 Mode D'emploi page 26

MAcHIne settInGs
water
settings
This function allows you to set various water settings.
Activate/deactivate the rinse function to briefl y clean the
rinse
internal circuits of the machine.
on
This function is activated by default by the manufacturer.
note: the rinse cycle is performed every time the
machine is started up, after the warming phase.
water fi lter
Activate/deactivate the warning to replace the water
fi lter.
off
Important note.
this setting automatically adjusts the parameters which allow the
user to perform correct machine maintenance.
select "on": only when the water fi lter is installed in the water tank as
shown on page 8.
This function is automatically activated after selecting "reload water fi lter".
select "off": when there is no water fi lter in the water tank.
Select "reload water fi lter" : when a new water fi lter is installed in the
water tank.
NOTE: if the water fi lter is not available, insert the small white fi lter
previously removed (see step 1 - page 8) into the tank.
Adjust the machine's water hardness setting. This will
water
hardness allow the machine to request descaling at the right time.
Measure the water hardness as shown on page 6.
3/4
23