Important; Maintenance And Storage - Ribimex Ribiland Prjet41P Manuel D'instructions Et D'utilisation

Additional Information for booster pump
- The pump starts and stops automatically when the pressure in the vessel is approximately 3 bar.
- Slowly open the discharge valve. The pump begins to discharge, without its engine running, through the
water supply in the tank.
- When the pressure in the tank drops below about 1.2 bar, the pump starts and remains on until the
pressure of the tank reach about 3 bar.
- To stop the pump cycles, slowly close the discharge valve.
- Always follow these instructions to avoid creating excess pressure in the system and avoid "water
hammer" effect.
5.3- Advise for users

IMPORTANT!

- Do not operate the pump without water in the pump body: extended operation of the pump when the
discharge valve is closed, can seriously damage the pump.
- In case of power failure, it is best to unplug the power outlet.
- In case of prolonged non-use, ensure to switch off the power.
VI. MAINTENANCE AND STORAGE
Before any intervention on product, ensure that product is disconnected from its power source.
6.1- Maintenance
- In winter, the pump must be carefully drained or placed in "frost" protected condition.
- Regularly rinse with clear water pump, including the suction line.
- Avoid pumping liquid containing abrasive materials such as sand.
- Before restarting, make sure of the good condition of every part of the pump.
- Clean plastic parts with a clean, soft cloth.
- Do not use aggressive cleaning product (solvents, detergents) or abrasive sponges or sharp or pointed
objects.
6.2- Breakdown
- Never attempt to dismantle the pump.
- If necessary, have it checked and repaired by an authorized centre (consult your dealer).
6.3- Storage
- Clean the pump.
- Pump must be stored in a dry, ventilated location. Always lock up product and keep out of reach of
children.
6.4- Disposal
- Do not dispose the product with household garbage. Do not throw into the environment.
- Dispose of the product in a collection centre for waste of electrical and electronic equipment, or a waste
drop-off centre; or seek advice from your local municipality.
- Disposal of the product, accessories and packaging should be carried out according to local regulations
governing environment protection.
Page 16 / 16