Parts List; Safety Instructions - Ribimex Ribiland Prjet41P Manuel D'instructions Et D'utilisation

EN - Original instructions
I. Parts List
II. Characteristics
WARNING:
Carefully read this instruction manual before operating this appliance.
Incorrect operation may cause injury and/or damages.
Please keep this manual for future reference.
Warning: This pump is not intended for swimming pools.
Under no circumstances should it be used for the cleaning or maintenance of swimming pools.
This pump is not intended for pumping drinking water.
I. PARTS LIST
II. CHARACTERISTICS
III. SAFETY INSTRUCTIONS
Before using this product, read and understand all safety instructions.
Always follow the safety instructions to minimize risk of damage to property, and to minimize any risk of
damages and injuries to persons and animals.
3.1- Symbols
Caution! Risk of injury and/or damage and/or deterioration of product in case of
non-compliance to safety requirements
Read the instructions manual.
Keep persons (esp. children) and animals away from product and working area
Disconnect product from its power source before maintenance, cleaning or any
intervention on product; or when you do not use product.
Disconnect product from its main power source, if product, power cable, or extension
cord is damaged or cut during operation.
Unplug product by pulling the plug. Do not pull the cable.
Do not dispose of this product with household rubbish or into the environment.
Dispose of this product in the nearest recycle centre.
Please contact your local authority or local recycle centre for further information for its
safe disposal.
3.2- READ ALL THE INFORMATION BEFORE OPERATING THE PRODUCT.
1. Keep work area clean
Cluttered areas and benches invite accidents and injuries.
2. Consider work area environment
Keep work area well lit (natural light or sufficient artificial lighting).
Keep work area well ventilated.
Do not use product where there is risk to cause fire or explosion (in the presence of flammable liquids,
solids or gas).
III. Safety instructions
IV. Getting Started
See Fig.1
See table 1
V. Operation
VI. Maintenance and Storage
Page 10 / 10