Inspection - Storage; Handling And Installation - Modine Eco Pae73 Manuel Technique

4. Inspection - Storage

4.1 Upon receipt of the model immediately check its state of integrity; immediately dispute with the transport company any
damage. The packaging is created according to the model, to the suitable means of transport and of handling.
4.2 The heat exchangers of the condensers and the gas coolers are supplied with a pre-charge of dry air at 2 bar and have
load couplings of 1/4" SAE. Check for the presence of pressure. In the absence of pressure immediately contact Modine
and report the problem on the transport document. Insufficient pressure indicates a loss due to damage incurred during
transportation.
4.3 The model must be stored in its original packaging in a place that is protected and away from weathering.
4.4 Do not place any other material on top of the packaging.
4.5 If a motor fan is switched OFF for a long period of time, it must be switched ON for at least 2 hours every month to remove
any traces of condensation that may have formed inside the motor.
4.6 The following rules apply when the unit must remain in storage for long periods of time. The unit must be stored indoors
and positioned according to its working position. This ensures functionality of the drainage holes of the fans. With the unit
stored in a damp environment, it is necessary to examine the outer covering to make sure that there are no damaged
points. If any are found, have them repainted. The fans must be protected with plastic reinforced sheeting or with some
other mechanical protection against water and/or contaminants which could damage the motors. The free surface of the
finned pack must be mechanically protected with a panel or with something similar. During storage, the fans must be
manually rotated at least once every 3 months.

5. Handling and installation

5.1 The packed model must be moved by qualified personnel using a forklift truck of adequate capacity, or by crane and/or
overhead travelling crane (see Chapter 7). Avoid any sudden movement and do not stand near the maneuvering area.
Always secure models to the lifting gear before handling. A large bump or strong push can cause the model to overturn.
5.2 Take care not to tilt the model during transport and handling. Danger of tipping over.
5.3 When transporting and handling the packed model, do not apply improper pressure to the packaging. Always keep the
packaging in the position indicated by the superimposed graphics.
5.4 Always use Personal Protective Equipment (PPE - see Chapter 12) when transporting and handling the packed model.
Mind the protruding and sharp parts (e.g. heat exchanger fins).
5.5 For handling with a forklift truck, the lifting brackets must be longer than the depth of the package and/or model.
32
www.modine.com
Figure 2