Riding The Motorcycle; Shifting Gears - Sherco 250 SE-R Manuel Du Propriétaire

250-300 SE/R

Riding the motorcycle

n Cold engine starting
1. Make sure the gear selector is in neutral
2. Activate the choke
3. Start the engine by pressing the starter button, with the throttle closed
4. Allow the engine to warm up for few minutes
5. Deactivate the choke
n Hot engine starting
Follow the instructions above without step 2-4 and 5.
n Shifting gears
- The positions of the gear selector are shown on (
- To find the neutral position, press the selector down into first gear (a resistance will be felt),
then move the selector up slightly.
1. Close the throttle before changing gears.
2. Engage the lowest gear.
3. Partially open the throttle while engaging the clutch.
n Parking
- Stop the bike with the stop button. The Keyless system will automatically switch off
the ignition after 30 secondes of no use of the bike.
Become familiar with all of the controls and their functions before using the vehicle.
88
p.81)
☛